R020932J1, Install Manual

Steam Generator & Fluid Heater Installation Manual

NOTE All Clayton-supplied water skids must be fully grouted in place once leveling and anchoring are complete.

D. Generator Skid The steam generator(s) and water treatment components as listed in “C” above, are all mounted on a single skid. Skid piping and electrical interconnections between components are included.

NOTE On SCR system skids, the SCR is mounted and piped, but removed for ship- ment for reassembly by the installing contractor.

NOTE Clayton reserves the right to ship loose any equipment that cannot be safely shipped in installed. Some skid components may require re-installation on site.

NOTE All Clayton-supplied water skids must be fully grouted in place once leveling and anchoring are complete.

3.3 CUSTOMER CONNECTIONS The required customer connections for the typical water treatment components included with open and deaerator feedwater receiver systems are identified in Tables 3-1 and 3-2 below. The type and size of each is provided on supplemental drawings and instructional literature.

Table 3-1: Hotwell (Open) and Deaerator Systems

Customer Connection

Feedwater a Outlet

Overflow/ Drain

Condensate Returns

Traps Returns

Steam Heating

Chemical Injection

Makeup Water

Skid Type

Vent Drain Overflow

None

X X X X X X X X

X X X X

X X X X X X X X X X X X

Condensate Skid

Water Skid

X X

X X

Generator Skid

X

X

X

a Feedwater outlet connections apply only on Condensate and Water Skids without Booster Pumps.

3-2

Sect03_FeedwtrSys_SF_g.fm

07/10/2015