R020932J1, Install Manual

Appendix D

NOTE If desired, the inner heater cover may be installed on the SE coil as- sembly prior to lifting it onto the main heating section.

c. Align the SE coil assembly’s bottom flange ring with the main coil section flange ring. d. Rotate the SE coil assembly, as needed, to align the feedwater inlet(s), as shown in Figure 2. e. Install the inner clamp bands around the main heating section flange ring and the SE coil assembly’s bottom flange ring. Secure the clamp bands with their attaching hardware. f. Place and align the inner heater cover on SE coil assembly. g. Install the inner heater cover clamp bands around the heater cover and the SE coil assembly’s top flange ring. Secure the clamp bands with their attaching hardware. Install Outer Shells a. Lift the rear outer shell piece (the shell piece with the cut-outs) up around the rear-side of the SE coil assembly and the feedwater inlet/discharge, allowing it to rest on the main outer shell below. Using a set of self-locking clamps, Vise-Grip ® pliers for example, clamp the SE outer shell to the main outer shell. b. Lift the remaining outer shell piece into place. Screw the two shell ends together. Align the assembled SE outer shells with the main outer shells below. c. Install the outer clamp bands around the main outer shell flange and the SE outer shell flange. Secure the clamp bands with their attaching hardware. d. Install the outer heater cover in the same manner as the inner heater cover was installed. Refer to steps f and g in the previous section. e. Install the patch plates around the feedwater inlet piping and the feedwater dis- charge piping. Install Piping a. Pre-assemble the SE Kit feedwater supply and feedwater discharge piping and flanges. b. Install the pre-assembled SE piping to the feedwater supply side and the feed- water discharge side of the machine, as shown in Figure 2.

IMPORTANT Before starting the steam generator/fluid heater, verify all piping connections, outer shell assemblies, and clamp bands are secure.

D-29

04/22/2015

R-16600 Rev. D